When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Up for sale is an almost pristine EMCOMaximat Super 11 Lathe and mill.
I have been buying and selling Emco lathes since1980, and this is the finest Super 11 Ihave ever seen.
This machine has a truly funny history.
It was originally purchased by an Arco Engineer forhis home shop.
He never set it up. It just sat on a bench for over 20years.
He sold it to a friend who tried to turn some woodon it. It did not work well.
The machine sat on his bench covered with sawdustuntil I bought it in 2015.
I bought it, cleaned it up, and bought a millingattachment for it.
There were a couple places I had to touch the paintfrom storage rash, but aside from that this machine is original.
I looked it over well, and there is no sign of anyreal use.
The bed is shiny and unblemished. There are a few tiny dings on the ways.
The milling table has no abrasions or dings. All the parts are like new.
This is gear-driven8-speed lathe, with forward and reverse.
It has a 15 speed gear-box for feeds and threading.
The milling head came from a “Super 13”. It had never been used.
It is the 6 speed milling head.
The milling column and base came from a “Super 11”
The column had been lying down in storage, and showssome staining.
The column is fine structurally.
The lathe has a D1-4 mount which holds a 6 inch originalEmco chuck with reversible jaws.
The lathe also has a 5-C collet drawbar and noseadapter, and a couple collets.
The saddle has a sliding compound and also has amilling table.
The tail-stock is an MT-2 and has a drill chuck andlive center.
There is a travel-stop for the bed, and I have sometool holders to throw in.
This is probably the largest lathe you can buy thatwill run on 110 volt household current.
The mill is running 220volt 3 phase. I have it hooked up with a staticphase-converter so that it can on run on 220 single phase.
I am just a home shop and I don’t want to ship this.
The machine probably weighs around 450 pounds.
I recommend a pick-up truck to haul.
I will rent a fork-lift on my end to load themachine.
There is also a Butcher-block top bench with 4drawers.
The paint could use some TLC but the bench functionsfine.
This machine is set-up under power, you are welcometo inspect.
I have been buying and selling Emco for 20 years.
I know the value of this machine.
Please do not throw me any lowball offers.