70\'s Sansui 771 AM/FM Stereo Receiver - 40WPC - Great Sound - Tested Works For Sale

1970\'s Sansui 771 AM/FM Stereo Receiver - 40WPC - Great Sound -Tested and Works -Nice Condition!
Very nice sounding quality vintage Sansui 771 Stereo Fm Analogue receiver with cabinet, 120/220 volt. This receiverwas built when Sansui was at the top of their game, with incomparable design, craftsmanship, and attention to detail and performance. This unit is heavy and well built. It has a very nice Phono input for your turntable, loudness, Speakers A/B/C, Muting, Mono, High/Low Filters, 2 Tape Loops, 2 Aux inputs, discrete output transistors for clearer sound and more dynamic range.

Thanks to its refined Circuit Board Module construction, the Sansui 771 outperforms many higher priced receivers in the field, offering a very superior power amplifier, an all-stage direct coupled OCL powerhouse delivering a continuous 40wpc to drive up to two pairs of speakers at a time. The preamplifier section and control sections are equally outstanding, providing inputs and controls for two tape decks, two aux, a microphone circuit, a phono circuit and an FM multiplex circuit.

CONDITION:
This unit has been tested and works well, sounds great and appears to have been well cared for. The casehas a few small nicks and scuffs, but nothing serious at all (see photos).
DIMENSIONS:
Width: 19 inches (480 mm)Height: 5-3/4inches (135 mm)Depth: 13inches (300 mm)Weight: 26 pounds, 12 ounces (12 range: FM, MW

Power output: 32 watts per channel into 8Ω (stereo)

Frequency response: 15Hz to 30kHz

Total harmonic distortion: 0.5%

Damping factor: 60

Input sensitivity: 2.5mV (mic), 2.5mV (MM), 100mV (DIN), 100mV (line)

Signal to noise ratio: 70dB (MM), 80dB (line)

Channel separation: 45dB (MM), 45dB (line)

Output: 100mV (line), 30mV (DIN)

Speaker load impedance: 4Ω to 16Ω

Semiconductors: 3 x FET, 3 x IC, 49 x transistors, 25 x diodes, 4 x zener diodes

Dimensions: 480 x 135 x 300mm / Weight: 12kg

---